Fit Brush in a specific size

[Jana]

I bought some circle brushes, I would like them to fit a specific punch I have
is there a way to size the brushes in a specific size?

[Wendy]

Hi ...

This is difficult to do .. even if you specify the size of the original document and work from there you still run into the problems that when you pring out it may not be exact.

The only time I use circles and a punch is when I am making tags ... and what I do then is to make the circles small and just use them as a guide.

What are you trying to do ??

Wendy :)

[lindylou50]

I'm assuming it is a circle punch. I would punch a circle out of card then scan this and use the image as a base and make your brush fit it, hope this makes sense it is much easier to do it than explain it!!!

[Jana]

Girls I got it a easier way
I made first one new doc on PSE on the size of the punch in my case
1.25
Then open another Us size paper doc
I stamped the circle adjusting the pixel size inside the small area
after I saw the pixel size for the punch to be 1.25" I then stamped in the other doc making sure the pixel size was the same.
It worked !

[Deborah]

Great information Jana. I'll have to try this

[Artcie]

Depending on what you are doing, turning on the grid might help for sizing, too!