guitarman3
January 29th, 2007, 10:41 PM
Hi, I'm using PRE 3.0 and have a specific problem that I don't know how to handle.
I'm doing a slideshow with all stills. Most motion keyframes I set go off without a hitch. But every once in a while I'll try to set a position keyframe where I'll grab the image handle to enlarge or reduce the image. All of a sudden the image pops into a super enlarged state where I can only view a very small portion of it. I do not drag it far enough to enlarge this much. Once this happens I can't reset the image size to my liking with keyframes. Even if I delete all the motion keyframes, the image stays overly enlarged. The only remedy is to delete the frame and re-insert it into the sceneline.
It's like the software takes over control. Has anybody seen this behavior? TIA for your help.
I'm doing a slideshow with all stills. Most motion keyframes I set go off without a hitch. But every once in a while I'll try to set a position keyframe where I'll grab the image handle to enlarge or reduce the image. All of a sudden the image pops into a super enlarged state where I can only view a very small portion of it. I do not drag it far enough to enlarge this much. Once this happens I can't reset the image size to my liking with keyframes. Even if I delete all the motion keyframes, the image stays overly enlarged. The only remedy is to delete the frame and re-insert it into the sceneline.
It's like the software takes over control. Has anybody seen this behavior? TIA for your help.